recorder method online : descant/sopranog natural
Dr. Brian Blood


home :: resources :: music theory & history :: recorder lessons :: music dictionary :: physics of musical instruments :: e-monographs


contents :: help page :: first things first :: fingering charts :: glossary of recorder terms :: Quick C :: Quick F :: comments or queries?site map :: quick search


First Octave: B :: A :: G :: E :: D :: C :: F :: F#/Gb :: Bb/A# :: C#/Db :: G#/Ab :: D#/Eb :: Second Octave :: Third Octave


This section gives advice on the following topics:

How To Finger The Note G
How To Tongue The Notes G, A and B
Raising and Lowering Your Fingers
How To Slur The Notes G, A and B


How To Finger The Note G

The third note we learn, G on the descant (soprano) recorder, lies on the second line from the bottom of the treble clef. Click on the play button in the Sibelius score to hear it. Below that we give the standard fingering for this note, the fingering you would use under normal circumstances.


Legend: = hole covered = hole uncovered = pinched thumbhole

Recorder Thumb 1 2 3 4 5 6b
6a
7b
7a
Bell
Descant
Tenor
  -----left hand-----------right hand-----

G
standard


Using the standard nomenclature, the fingering for first octave G is written 0 1 2 3.

How To Tongue The Notes G, A and B

In the previous lessons you discovered how to tongue the notes A and B. You will find that the same tonguing stroke and strength with the fingering given above will produce a good G. Moving between the three notes, you need to coordinate the tongue and finger movements so that there are no extraneous sounds in piece no. 3a. As in the previous lesson try detaching the notes so that there is a noticeable period of silence between them. Then, shortening the silences, make the musical line less detached and more legato.

Raising and Lowering Your Fingers

As you begin to move more than one finger at a time you will find it difficult to keep all the movements coordinated. You should try, from the outset, not to raise your fingers too far above the holes when uncovering finger holes. The best distance is that which allows you to return the finger to the recorder as quickly and as directly as possible, say 5-10 mm from hole surface to finger pad. When raised, the finger should lie directly above its own hole. If the fingers drift away from this position you will find yourself 'hunting' for the holes each time you need to cover them. When the fingers are too high or unevenly high, it is more difficult to move them up and down neatly. When going from B to G, you want get the 'feeling' of a single block of fingers moving onto the recorder, rather than two individuals. Try moving back and forth between the two notes B and G until you feel the two fingers moving as one block. Try piece no. 3b.

How To Slur The Notes G, A and B

The exercise we have given you above can be extended to use slurs as well as tongued notes. Again, play particular attention to neat slurring; just the tow notes with a minimum of extraneous noise in between them. Try piece no. 3c which makes use of extensive slurring before moving onto the next lesson.